Safety information
Radio
FCC
Federal communications comission (FCC) statement
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:
this device may not cause harmful interference, and
this device must accept any interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Interference statement (Class B)
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
RF Exposure statement — Fixed installation
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment must be installed and operated with a minimum distance of 20 cm between the radiator and any person. This device is intended for fixed, permanently installed indoor or outdoor equipment and is not designed for portable or handheld use.
Antenna statement
Use only antenna types and maximum gains approved for this module, or antennas of the same type with equal or lower gain. Using non‑approved or higher‑gain antennas may violate FCC regulations and may require additional authorization. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter except in accordance with FCC multi-transmitter product procedures.
Outdoor operation and 5 GHz band restrictions
This device is approved for outdoor use when installed in accordance with the manufacturer’s installation instructions.
Operation in the 5 GHz U-NII bands must comply with 47 CFR §15.407 (including applicable conducted/EIRP power and PSD limits, DFS where required, and any elevation mask limits). In the 5.15–5.25 GHz band (U-NII-1), deployment conditions depend on the device class and must follow §15.407(a)(1). The device implements DFS where required to detect radar signals and avoid interference.
ISED
Licence-Exempt statement (EN/FR)
English: This device contains licence‑exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence‑exempt RSS(s). Operation is subject to the following two conditions: (1) this device may not cause interference; and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
Français: Le présent appareil contient des émetteurs/récepteurs exempts de licence conformes aux CNR d’Innovation, Sciences et Développement économique Canada. L’exploitation est autorisée aux deux conditions suivantes : (1) l’appareil ne doit pas produire de brouillage; et (2) l’utilisateur de l’appareil doit accepter tout brouillage, y compris tout brouillage pouvant entraîner un fonctionnement indésirable de l’appareil.
RF Exposure/Exposion aux RF — Fixed/Mobile installation (≥20 cm)
English: This equipment complies with ISED RSS‑102 RF exposure limits for an uncontrolled environment. Install and operate the equipment with a minimum distance of 20 cm between the radiator (antenna) and any person.
Français: Le présent équipement est conforme aux limites d’exposition aux RF d’ISDE (CNR‑102) pour un environnement non contrôlé. Installez et utilisez l’équipement en respectant une distance minimale de 20 cm entre le radiateur (antenne) et toute personne.
Antenna and Co-location/Antenne et co-implantation
English: Under ISED regulations, this radio may only operate using an antenna type and maximum (or lesser) gain approved for this transmitter by ISED. Using other antenna types or higher‑gain antennas may require additional authorization. This transmitter must not be co‑located or operating in conjunction with any other antenna or transmitter unless the final product has been evaluated for multi‑transmitter RF exposure compliance.
Français: Conformément à la réglementation d’ISDE, ce dispositif ne peut fonctionner qu’avec des types d’antenne et des gains maximaux (ou inférieurs) approuvés pour cet émetteur par ISDE. L’utilisation d’antennes d’un autre type ou d’un gain supérieur peut exiger une autorisation supplémentaire. Cet émetteur ne doit pas être co‑implanté ni fonctionner en conjonction avec une autre antenne ou un autre émetteur, à moins que le produit final n’ait été évalué pour la conformité à l’exposition RF en configuration multi‑émetteurs.
5 GHz LE-LAN operation (Canada)/Fonctionnement LE-LAN 5 GHz (Canada)
English: In the 5150–5250 MHz band, LE‑LAN devices are limited to indoor use. Where required by RSS‑247, the device implements Dynamic Frequency Selection (DFS) to detect radar signals and avoid interference. The product must meet any additional Canadian restrictions applicable to specific sub‑bands (e.g., weather radar protections).
Français: Dans la bande 5150–5250 MHz, les dispositifs LE‑LAN sont limités à une utilisation à l’intérieur. Lorsque requis par la norme RSS‑247, l’appareil met en oeuvre la sélection dynamique de fréquences (DFS) pour détecter les signaux de radar et éviter le brouillage. Le produit doit respecter toute restriction canadienne supplémentaire applicable à certaines sous‑bandes (p. ex., protections des radars météorologiques).
Handling and operation
If you do not obey these Warnings, injury to persons can occur.
Do not touch the heat sinks when the camera is powered on. The heat sinks become hot when the power is on.
If you do not obey these Cautions, damage to the equipment can occur.
Protect the camera and accessories from dirt, dust, impacts, and liquids.
Protect the microphone panel from physical contact. Do not touch the microphone holes.
Only use the accessories and spare parts that Flir provides.
Do not disassemble the camera.
Do not use a damaged camera or accessory.
Declaration of Conformity
The complete Declaration of Conformity can be accessed at: https://support.flir.com/resources/DoC.